Widescreen Gaming Forum

hello !!
i need your help my problem is that, i can't change to 1680x1050 in the powerdesk . this resolution is listed but when i try to get it as a single screen it show a 4/3 resolution 1600x1200 !!!
my triplehead configuration is abble to show 5040x1050 on 3 widescreen 22" but when i try to swap to single on 1680x1050 it's not possible !! is somebody can tell me why ? (i run in 57 hertz monitor with 3samsung 2 T220 and 1 2253lw in the center)i have updated the firmware and intalled the latest software with the wizard.
there's something strange in my quicklaunch icons bar of my ATI card
the 1680x1050resolution is not displayed!!!
i get in order
1440x900
1600x1200
3072x768 etc.... :roll:
thanx for your help !!!! :!: :!: :!: :!:

Can you setup a custom resolution of 1680x 1050 @60Hz in your ATI control panel and then apply it?

problem fixed
i have run the wizard again and select a single display for new resolutions my 1680x1050 output is effective now . I can switch without problem
between 5040x1050 in triplescreen and 1680x1050 in single screen !!! ready for gaming thanks a lot :)